Lifute Rope Mesh Belt Factory produces half body safety belts, half body rescue safety belts, half body safety belts with bumper, and double hook half body safety belts

The usage of a half body safety belt is a type of safety equipment worn on climbers to reduce falling injuries. In a half body safety belt, the waist belt and protective ring are the main load-bearing parts, while the other parts are basically not under the weight of the human body. The leg straps are designed for convenience and comfort. The specific wearing method of a half body safety belt is as follows: 1. Check whether the strap and safety rope are reliable. If there is wear, mildew or other phenomena, the equipment should be replaced to avoid safety hazards. 2. Connect the strap and safety rope, and fasten the chest strap on the body in a reverse manner, ensuring that there is still a reserved length of more than 10 centimeters for the chest strap after fastening. Next, fasten the waist belt and leg straps in sequence, using the same reverse buckle method and reserving an appropriate length. 3. Finally, before climbing high into the sky, it is important to check each other's safety belts and ensure that they are securely fastened. Precautions for wearing a half body safety belt: 1. When wearing a half body safety belt, in order to avoid compressing the diaphragm, the position of the waist belt should be above the hip bone and leave a gap of 3-5 centimeters below the waist, otherwise it will affect the breathing of the human body. After putting on the seat belt, it should be pulled down forcefully, but in no case should it exceed the position of the hip bone. When wearing a seat belt, the leg straps should have a certain degree of looseness to make the human body feel comfortable. If it is an adjustable leg strap, at least 5 centimeters of strap length should be reserved after fastening the bag. After fastening the belt with a buckle, at least 8 centimeters of belt length should be reserved for the belt, otherwise there is a risk of it being pulled apart after acceptance. When fastening the belt, first thread the belt into the buckle like a belt, and then reverse it through the buckle to make the belt more stable.